How much will springs settle shortly after installing? Learn how to judge your new spring installation by knowing exactly what to expect from a freshly manufactured set from EATON Springs.
Shocks Raise Rear Of ’56 Bel-Air
Mike, I have a stock 1956 Belair which is sitting kind of low in the rear. I have installed new Load Leveler shocks that raised the rear a little, but I need to raise rear another 1-2 Inches. Can this be done with just adding a leaf? The original springs appear to be OK, she […]
Diagnosing ‘Wiggle’ At High Speeds
Mike, First of all I want to thank you for letting me ask a question. I have a ’56 Belair with an LT-1, 700R Trans. This car did have a 454 in it when I got it. Anyway, since removing the 454 and installing the LT-1, I am having problems with the rear-end wiggling back […]
Corvette Rear, Steel Spring Rearching and Fiberglass
Q -Mike, Hope you can give me some direction here. I have an ’81 Corvette that has one side lower than the other in the rear. The local shop replaced the rear tie bolts, but it still is tilting to one side. They think it is the leaf spring and recommends I replace it with […]
If Not Rear Springs, What Causes A Leaning GTO?
Mike, I purchased a set of new rear springs from you for my 1967 GTO and when I put them in the car leaned to the driver’s side about 3/4 of an Inch. The lean was there with the old springs but I thought the new springs would level it out. I even switched the […]
Stock Mono Leaf vs. Multi-Leaf Replacement
Is there an advantage to putting multi-leaf springs on a vehicle with mono-leaf springs?
Do Heavy Duty Springs For ’63 Galaxies Change Ride Height?
Hello, I have a question about 1963 Ford Galaxie rear leaf springs. I was told that a 1963 Galaxie with 6 leaf spring packs sits 3 Inches lower than a car with 5 leaf spring packs. Do you agree with this? Thank you for your time, -Cliff Cliff, The one who is spreading this information […]